Commissioning; Set Up The Device; Power Supply; Switch The Device On/Off - Heidolph Hei-MIX Reax top Betriebsanleitung

Commissioning

Commissioning

Set up the device

CAUTION
Risk Of Slipping!
The vibration during operation can cause the device to move over
the mounting surface and/or fall to the ground.
➜
➜ Place the device on a solid level and horizontal surface for use.
➜ Before switching on, make sure that the device is sufficiently stable.
➜
Keep all contact surfaces clean and dry.

Power Supply

Always use the supplied power supply cord provided with the
device! Observe the instructions in section "Electrical safety" on
page 26.
The device must only be supplied with power from a properly
grounded mains socket-outlet.
Connect the power supply cord
➜ First, connect the supplied power supply cord to the appliance plug.
➜ Then connect the power plug to a grounded mains socket-outlet.
Disconnect the mains connection cord
➜ First, remove the mains plug from the mains socket-outlet.
➜ Then disconnect the power supply cord from the device connector.

Switch the device on/off

➜
Set the speed to zero before switching on the device. To do this, turn the speed
controller fully anti-clockwise.
➜ Use the on/off switch to turn the device on or off.
– When on, the on/off switch lights up green.
If the speed is not set to zero when the device is switched on, the
shaking movement starts immediately!
Reax Control: In this case, the Reax Control model emits an
acoustic warning signal.
Observe the instructions for the correct positioning of the
device!
31