Electrical Connections; Laying Cables - Waeco DIY-12 Bedienungsanleitung

DIY-12.book Seite 31 Freitag, 24. Februar 2006 3:51 15
DIY-12
6.3
This switch is available as an accessory.
➤ Find a suitable location in the engine compartment and drill a hole with a
➤ During installation make sure the distance to the closed bonnet is
➤ Test the switch function after installation.
7
7.1
Downloaded from www.Manualslib.com
Installing the bonnet contact switch (optional
accessory)
Caution
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
diameter of 8 mm.
between 22 mm and 27 mm.
Use putty to check this distance.
You can further reduce the minimum distance by shortening the switch.

Electrical connections

Laying cables

Caution
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
Note
As far as possible, use original ducts for laying the cables, or other
suitable options such as panelling edges, ventilation grilles or
dummy plugs. If there is no rubber plug, make a suitable hole with
a diameter of around 13 mm and insert a cable sleeve.
Note
Cables and connections which are not properly installed will cause
malfunctions or damage to components. Correct installation of
cables and connections ensures lasting and trouble-free operation
of the retrofitted components.
manuals search engine
Electrical connections
31