Function Table; Programming The Alarm System - Waeco DIY-12 Bedienungsanleitung

DIY-12.book Seite 37 Freitag, 24. Februar 2006 3:51 15
DIY-12
Switching off panic/search mode
➤ Press the ON/OFF button on the remote control.
✓ The panic mode is switched off.
9.5
The following table lists all of the functions and how you can activate them.
Function
Activating
Activation with the shock sensor
off
Deactivating
Panic mode
Vehicle search function
3 s Press the appropriate button and hold it down for 3 seconds
10
10.1
The DIY-12 alarm system can be operated with up to four remote controls.
If you program a new remote control, you must reprogram all the existing
ones.
➤ Disarm the alarm system (see "Disarming the alarm system" on page 36).
➤ Switch the ignition on and off seven times.
➤ Switch on the ignition again within eight seconds.
✓ The alarm siren sounds three signals after eight seconds.
✓ The alarm system is ready for programming.
Downloaded from www.Manualslib.com

Function table

Press the appropriate button

Programming the alarm system

Programming remote control devices
manuals search engine
Programming the alarm system
ON/OFF
Condition
button
Ignition off
Ignition off 1.
Ignition off
P button
2.
3s
3s
37