Herunterladen Diese Seite drucken

grabner SPEED Eignerhandbuch Seite 12

Motorboot
Vorschau ausblenden Andere Handbücher für SPEED:
zUBEHÖR
– in der Serienausstattung nicht enthal-
ten
► Sitzbrett Mitte – für eine zusätzliche
Person
► Sitzbrettbügel - zur Absenkung der
Sitzbretter um 12 cm
► Sitzbrettpolsterung - für weichen
Sitzkomfort
► komfortsitz – mit hoher Rückenleh-
ne für optimale Rückenabstützung
► Sitzbrett-polstertasche
höchsten Fahrkomfort und Ordnung
im Boot
ACHTUNG: Bei verwendung der
Sitzbrett-polstertasche ist die knie-
sitzposition nicht möglich.
► Ruder und Ruderhalterung - Die
Ruderhalterung kann der Länge
nach individuell an der Ösenleiste
befestigt werden.
Montage:
Entfernen Sie die schwarzen Rän-
delmuttern und nehmen Sie die zwei
Teile auseinander.
Stecken Sie den Teil mit den Schrau-
ben von außen, in der gewünschten
Position, durch die Ösen der Ösen-
leiste.
Stecken Sie den zweiten Teil von in-
nen auf die Schrauben und schrau-
ben Sie mit den Rändelmuttern fest.
Stecken Sie die Ruder mit den Ru-
der-gabeln in die Aufnahmen der Ru-
derhalterungen
HINWEIS: In der Aufnahme befindet
sich ein Sicherungsdorn!
Bei nichtverwenden der Ruder kön-
nen Sie die Ruder, mit einem Gurt
oder leine an der Ösenleiste fixieren.
12
– not contained in standard accessory
supply
SPEED
► Midship saet-board - accommoda-
teadditional person
► Seatboard retaining-bracket - for
low seat position
► Seatboard-padding - for soft seaing
► Comfort-seat - with high aspect rear
panel for best back support.
► Seat-board pad with bag - for com-
fort and on board tidiness
für
CAUTION: When the seat-board pad
with bag is fitted, paddling in knee-
ling position is not possible.
► Oars and rowlocks - Rowlocks can
be attached individually on the eyelet
lip.
Fitting
Remove the black knurled nuts and
take the pieces apart.
Feed the part with the bolts through
the eyelets into the desired position
on the eyelet lip.
Place the second part from the inside
onto the bolts and fasten the knurled
nuts firmly.
Push the oar with the rowlock into
the rowlock-socket.
NOTICE: The socket is supplied with a
securing bolt!
When not in use, the oars may be se-
cured to the eyelet lip by means of a
line.
ACCESSORIES
loading

Diese Anleitung auch für:

Mustang s