Gb Starting Locomotive Operation; Maintenance Of The Model - Roco 72046 Bedienungsanleitung

GB
Starting locomotive operation
Unwrap model: Take the loco carefully out of
the packing with the help of the foil (fig. 1).
Very important!
Before taking into service your model these
bearings of the coupling rods must be oiled as
otherwise there would be the risk of bad run-
ning qualities of dramage on he locomotive.
Operating instructions: Before use is advisab-
le to let the loco go around about 30 minutes for-
wards an 30 minutes backwards without load, to
obtain an optomal circuit and best tractive power.
The smallest radius this model should run is R32
(358 mm) of the ROCO track system.
Your locomotive will run smoothly on clean tracks
only. For this purpose we recommend using item
no. 46400, Roco track cleaning van, or item
no. 10002, Roco track cleaning rubber, for
removing heavy dirt.
Fittings: Operation is possible with different
More information about the sound decoder can be found here
10
couplings (fig. 2). We recommend using the Roco
close coupling.
In the enclosed accessory bag you will find small
kits to be fitted on your locomotive. Please mount
them cautiously. Attention! Use glue only if
indicated (fig. 2).
Running in digital mode:
First remove Tender body (fig. 4). Then remove the
jumper from the interface. Finally put the plug of
the chip into the interface as shown in fig. 5.
GB

Maintenance of the model

To enjoy your model for a long time, it is necesary
to service it regulary (i.e. after it has been in ope-
ration for approximately 30 hours).
1. Lubrication: Apply tiny oil drops to spots
marked in fig. 7. Prior to lubrication dismantle the
loco body or the tender body (fig. 3,, fig. 4). We
recommend using item no. 10906, ROCO oiler.
For lubrication the gearparts (e.g. cogwheels,
worm) we would recommended our ROCO speci-
al grease (item no. 10905).
Attention: Please do not oil these parts when
using our grease.
2. Change of traction tyre: The change of
traction tires requires fine mechanical knowled-
ge. Please contact your Roco dealer or a specialist
workshop.(fig. 6).
3. Carbon Brush Changing: First remove tender
body (fig. 4), and then the carbon brushes (fig. 4).
3