MA lighting grandMA2 Schnellanleitung Seite 32

Lifting the monitor wing
For adjusting the angle of the monitor wing hold down the MA – button at the same time as the button
Up to raise the monitor wing
or Down to lower the monitor wing until the wing is at desired position.
NOTE: Always lower the monitor wing before moving the desk.
ATTENTION: When lowering the monitor wing, keep clear and clear of this area of operation!
Adjusting the intensity of the screens
For adjusting the intensity of the screens hold down the MA – button at the same time as the number button
1 for the lid lights
or 2 for the screen 2, 3 and 4 (depends on type
of console)
or 3 for the screen 1 (internal command screen)
or 4 for the lighted buttons...
If the lifting – device is used intensively, it can happen, that the
motor ist temporary switched off by the temperature control.
During that period adjust the monitor-wing manually: press and
hold MA and Set – button und adjust the wing. After releasing
the buttons this position is fixed.
and
+ button for increasing
the intensity or
- button for decreasing
the intensity.
grandMA2
Data
Transport
Important Safety
Instructions
Safety and
Environment
Quickstart
Connect
Quickstart
ON / OFF
Maintenance
Conformity