Inhaltsverzeichnis
Werbung
Charging
Positioning
1 2
"
The minimum recommended separation distance is shown above.
IMPORTANT: Incorrect positioning can cause noise and interference problems.
10
Downloaded from
www.Manualslib.com
1. Slide the headset into the charging
cradle. The earpiece with the micro-
phone goes into the cradle.
2. Gently press down on the the head-
set to ensure that the headset is in
the correct position. The amber
charge indicator light on the base
will flash while charging and will
change to solid amber when fully
charged.
• 20 minutes = minimum charge
to continue setup
• 3 hours = full charge
manuals search engine
Adjusting Fit
1
2
NOTE: Depending on your preference, you can
replace the pre-installed leatherette ear cushions
with the included alternative foam cushions.
1. Adjust headband to fit.
2. Rotate noise-cancelling microphone until it is pointed towards your chin.
Multi-shift Pairing
1
Enable
Disable
1. To pair another headset to the same base, you must first enable the multi-shift
pairing feature. Long press (5 sec.) the speaking volume minor adjust up button
on back of the base until the power indicator flashes.
2. Place a charged headset in charging cradle. The red indicator light on base will flash
for 2 seconds if the multi-shift pairing feature is enabled. Within 10 of doing so, press
either the "+" or"-" listening volume button for 3 seconds until the green talk indicator
lights to indicate pairing mode and goes out after successful pairing. Repeat steps 1
and 2 if headset and base do not link when call control button is pressed.
NOTE: Only the last paired headset will work with the base. You must NOT be in talk mode
(on a call) to enable or disable this feature.
To disable the multi-shift pairing feature, long press (5 sec.) the speaking volume minor
adjust down button until the power indicator light flashes.
3
2
11
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
