Assembly Of The Swinging Drawbar - Stocker 303 Benutzerhandbuch

6
Assembly of the irrigation bar for grass
Assemble the lateral components of the lance with the rods (104, 106), joints (103, 102, 101) and
nozzles (100). It is possible to mount up to 6 nozzles on the lance. For the 6 nozzles setup, use
all the suplied rods (104, 106). With the handy sealing disks (127) it's possible to seal some of the
nozzles in order to not use them.
Assemble the sides of the lance onto the T joint (107), previously mounted on the pump.
96
Art. 303 / Art. 304
Wheelbarrow battery pump 80 L and 100 L
Art. 303 / Art. 304
Wheelbarrow battery pump 80 L and 100 L

Assembly of the swinging drawbar

With bolts (124) and nuts (38), fasten the S plate (125) onto the metal rod (123) through
the most internal holes. Insert the small piston (126) into the end hole and secure it with
the fastening ring (121).
Connect the metal rod (123) onto the pole of the fork (122) with bolts (124) and nuts (38).
With the 3 holes, it is possible to slightly adjust the length of the drawbar.
Insert the two poles (122) into the dedicated holes on the chassis ad fasten with bolts (21)
and nuts (38).
Release the bolts (120) and fastening rings (121) of the metal foot (41) and move it
upwards. Fasten it horizontally using the same bolts (120) and fastening rings (121).
For further information about the product, please contact info@stockergarden.com.
Sign up to our newsletter and keep up to date with our latest news info@stockergarden.com
6
97