Replacing The Battery; Troubleshooting - Bissell EV675 Benutzerhandbuch

Replacing the Battery

1
Turn the Power Switch to the OFF position.
Use a Phillips-head screwdriver to remove
the two screws and battery cover. Remove
the battery and disconnect.
Replacing the Edge Cleaning Brushes
1
Use a Phillips-head screwdriver to
remove the screw. Pull up on the base
of the brush.

Troubleshooting

Problem Possible causes
Power Switch on the robot is turned OFF (0).
The batteries need replacing.
Remote
Control
The Remote Control is too far from the robot.
doesn't
work
The Remote Control is not paired with the
properly
robot.
The Dust Bin is full.
Low or no
suction
One or both filters are missing or clogged.
The battery is not installed
Robot
properly.
won't
start
Battery power is low.
Doesn't
Cleaning interrupted by error.
return to
Docking
Robot is too far away from the Docking
Station
Station.
after
cleaning
8
2
Connect the new battery and install into
battery compartment. Use a Phillips-
head screwdriver to replace the battery
cover.
2
Push the brush directly onto the
holder. Replace the screws with a
Phillips-head screwdriver.
Remedies
Turn ON (I) the Power Switch located on the side of the robot.
Replace with 2 AAA batteries.
Ensure the Remote Control is within 10 feet of the robot.
Turn the robot OFF. Hold down the Start Button on the remote.
Once the clock flashes on the display, continue to hold the Start
Button and turn ON the robot. The robot will beep three times
once successfully paired.
Empty the Dust Bin.
Check to see if the filters are in place and clean as needed.
Please refer to the "Replacing the Battery" section on
page 10.
Charge the robot's battery using the Docking Station.
Please refer to the "Status Light and Error Notifications" section
of this guide.
Limit or control the range of the robot by closing off rooms, or
by using the manual cleaning arrows on the remote control.