Bissell EV675 Benutzerhandbuch Seite 6

Getting Ready to Clean
With Remote Control
NOTE: Be sure the Power Switch on the Robot is set to the ON position.
You can change the cleaning pattern of the robot by pressing one of the following buttons:
Auto Mode
Robot will drive in a straight path until it encounters an obstacle and change
direction.
Spiral Mode
Best for concentrated cleaning.
Wall Mode
Best for cleaning along walls and edges.
Single Room Mode
Best for cleaning a single room. It's recommended that you close any doors to
contain the robot.
Manual Mode
Best for directing the robot to a particular area.
Return to Dock
Press to return the robot to the Docking Station.
Without Remote Control
1
Press the Power Switch to the
ON (I) position.
3
When finished, press the Start/Stop
Button again to stop the robot.
6
2
Press the Start/Stop Button on the top
of the robot to start cleaning.
4
When the vacuum is in standby mode,
press the Start/Stop button twice
continuously. The vacuum goes into
recharging mode with the
flashing blue.
button