Setting Up The Remote Control; Set The Clock - Bissell EV675 Benutzerhandbuch

Setting Up the Remote Control

Pair the Remote to the Robot
NOTE: Be sure to install batteries in the remote.
1
While the Power Switch on the side of the
robot is OFF (0), press and hold the Play
Button on the remote for 5 seconds until
the clock icon on the display flashes.

Set the Clock

1
Set the time by pressing
the Clock Button on the
Remote Control and
holding until the icon
flashes on the Remote
Control display.
Schedule Cleaning Sessions
NOTE: Be sure the clock is set to the correct time before scheduling cleaning sessions.
1
Press the Schedule
Button on the Remote
Control. The icon will
begin to flash on the
Remote Control display.
NOTE: To cancel a scheduled cleaning session, press and hold the Schedule Button on
the remote.
2
Continue to hold the Play Button and
turn the robot ON (I).
NOTE: The robot will beep three times to
indicate that it has successfully paired.
2
Use the directional
arrows to set the hour
and minute.
2
Use the directional
arrows to set the hour
and minute for your
robot to start cleaning.
3
Press the Clock Button
again to save the time
setting.
NOTE: The robot will
beep once to confirm
the time has been saved.
3
Press the Schedule
Button again to save the
schedule setting.
NOTE: The robot will
beep once to confirm the
schedule has been saved.
5