Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
(5) Operation
Connect the cable to the side channel blower at socket F, and switch on the operating switch.
Connect the HWA with the power cable (G) to an earthed socket. Turn on the switch (A). This is
indicated by a green operation light.
If there is no water in the water separator, the side channel blower will start operating.
When the pump starts up, the energy consumption is shown on the energy meter (D). Therefore,
please note down the meter readings before drying starts.
When operating the side channel blower, please observe: The ampere meter of the side channel
blower must be in the green field, when the indicator reaches into the red the airflow of the hose is not
correct. After a while, the unit will start switching off the motor intermittently or the motor protection will
trigger. In addition, the HWA may be damaged.
In the pumping phase the side channel blower is switched off automatically and is switched on again
after pumping.
Suction hoses as well as pressure hoses with a diameter of 38 and 50 mm can be connected to this
unit.
A
On/Off (main switch)
B
"Empty" button
C
energy meter
The setup and connection of the water separator is carried out according to the following schematic:
Connection of
suction hose
(SKV)
Connection of
pump-off hose
(3/4 inch)
D
Power socket 230V /10A
Connection of
suction hose
(bottom)
14
E
power cable
HSD _ Silencer
SKV _ Side channel blower
HFB _ Hepa filter box
HWA _ Water separator
EN
Werbung
Kapitel
Inhaltsverzeichnis
