Pc Input Typical Display Modes - Toshiba 43 UL2B Serie Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für 43 UL2B Serie:

Bedienungsanleitung (47 Seiten)

Inhaltsverzeichnis

Verfügbare Sprachen

• TV is not receiving any signal. Make sure the correct

source has been selected.

• Is the antenna connected properly?

• Is the antenna cable damaged?

• Are suitable plugs used to connect the antenna?

• If you are in doubt, consult your dealer.

• Check if the TV sound is muted. Press the Mute

button or increase the volume to check.

Remote control - no operation

• The batteries may be exhausted. Replace the

Remote control - no operation

• The batteries may be exhausted. Replace the

• The batteries maybe inserted incorrectly. Refer to

the section "Inserting the Batteries into the Remote".

No signal on an input source

• It is possible that no device is connected.

• Check the AV cables and connections from your

• Check the device is switched on.

The Image is not centered in VGA source

To have your TV automatically center the image, enter

the PC Position menu in Picture menu, highlight

Autoposition and press OK. Wait for it to finish. In

order to set the position of the image manually you

can use H Position and V Position options. Select

the desired option and use Left and Right directional

buttons on the remote to set.

Recording unavailable

To record a programme, you should first correctly

connect a USB storage device to your TV, while the

TV is switched off. You should then switch on the TV to

enable recording feature. If you cannot record, check

the storage device is correctly formatted and there is

sufficient space.

USB is too slow

If a "USB disk writing speed too slow to record"

message is displayed on the screen while starting a

recording, try restarting the recording. If you still get

the same error, it is possible that your USB storage

device does not meet the speed requirements. Try

using a different USB storage device.