Werbung
Verfügbare Sprachen
Verfügbare Sprachen
______________________________________________________________________________
EN
FIGURE D
On/Off/Speed switch (Figure D)
Push the left-hand side three-position switch to the appropriate position to turn the Turntable
on. The position in the direction of the Turntable's back (indicated by two lines) sets the 45 RPM
speed while the position in the direction of the front (indicated by a single line) sets the 33 1/3
RPM speed. The center position turns the Turntable off. BE CERTAIN TO REMOVE THE CLEAR
PROTECTIVE CAP UNDER THE STYLUS BEFORE PLAYING A RECORD.
Drive pulley (Figure A, #2)
Position the included flat drive belt over the pulley as described above in "Assembly".
FIGURE E
Line and Phono output and Switch (Figure E)
Turntable Analog has an assignable analog output – LINE OUT with integrated phono preamplifier
and PHONO OUT. Position the switch to LINE OUT to use with the Auxiliary input on your Como
Audio model or other music system's Aux input. If connecting to a Como Audio system, ignore the
ground wire attached to the RCA cable. There is an included 3.5 mm adapter to place over one end
of the included RCA audio cable for the Como Audio system's Aux input.
Position the switch to PHONO OUT if you prefer to use an outboard phono preamplifier or are
connecting to a receiver or integrated amplifier with a dedicated Phono input. Make sure the
5
Werbung
