General View Of Application; Application - WAGNER Super Finish 21 Betriebsanleitung

Safety regulations
For reasons of function, safety and durability
i
use only original WAGNER high-pressure
hoses.
b
Electrostatic charging (formation of
sparks or flame)
Under certain circumstances, electrostatic
charging can occur on the unit due to the
rate of flow of the coating material when
spraying. On discharging this can result in
Danger
the emergence of sparks or fire. It is there-
fore necessary that the unit is always earthed through
the electrical installation. The connection must take
place through a correctly earthed two-pole-and-earth
socket outlet.
b
Using unit on construction sites
Connection to the mains only through a special feed
point, e.g. through an error protection installation
with INF ≤ 30 mA.
b
Loading the socket at the unit
Do not load the socket with more than 1000 Watt. Un-
roll any connected cable drum completely.
b
Ventilation when spraying in rooms
Adequate ventilation must be guaranteed for the removal
of the solvent vapours.
b
Suction installations
These are to be set-up by the user of the unit according
to local regulations.
b
Earthing of the object
The object to be coated must be earthed.
b
Cleaning units with solvents
When cleaning the unit with solvents, the sol-
vent should never be sprayed or pumped
back into a container with a small opening
(bunghole). An explosive gas/air mixture can
Danger
be produced. The container must be earthed.
b
Cleaning the unit
Danger of short circuit through pene-
trating water!
Never spray down the unit with high-pres-
sure or high-pressure steam cleaners.
Danger
Socket on unit
Only carry out damp cleaning in the area
of the socket and the ON/OFF switch
when the mains plug is removed.
Super Finish 21 and 23
Downloaded from www.Manualslib.com manuals search engine
g
b
Work or repairs on the electrical
equipment
Only have this work carried out by a qualified electrician.
No liability will be taken for incorrect installation.
b
Working on electrical components
Remove the mains plug from the socket for all such
works.
b
Setting-up on uneven surfaces
with Super Finish 23
The front side of the unit must point downwards to pre-
vent sliding away.

2. General view of application

2.1 Application

All painting jobs in the workshop and on the building
site, small dispersion work with the spray gun or inter-
nally fed Airless roller.
Examples of object of spraying
Doors, door frames, balustrades, furniture, wooden clad-
ding, fences, radiators (heating) and steel parts, internal
ceilings and walls.
General view of application
Super Finish 23
27