Beurer Alessandra Ambrosio AHC 26 Gebrauchsanweisung Seite 51

> The heat-up phase is shown through three alternating flash-
ing bars in the LED display [2]. When the three bars are
permanently illuminated, the temperature shown in the LED
display [2] has been reached and the hair straightener is
ready for use.
> The temperature can be increased by pushing the button [3].
The temperature can be decreased by pushing the button
[5].
> We recommend the following temperature settings:
> 100°C to 140°C:
- Fine, brittle, coloured or bleached hair
> 140°C to 160°C:
- Normal hair
> 160°C to 180°C:
- Thick and resistant hair
> The temperature can be fixed by pressing the [5] button for
3 seconds. In the LED display [2], the button lock
pears. To cancel the button lock
for 3 seconds. In the LED display [2], the button lock
goes out.
> Divide the hair into individual sections of approximately 3
to 4 cm. Hold the section taut and place it between the hot
plates [1] at the roots.
> Slowly move the hair straightener from the roots to the tips
in a fluid motion. Do not hold the hair straightener in one
place for more than two seconds. This will achieve the best
results without subjecting your hair to excess stress or dam-
age.
> You can style the ends of your hair by turning the hair
straightener inwards or outwards before running it over the
tips of the hair.
[11], press the [5] button
51
[11] ap-
[11]