Toshiba V-752EW Serviceanleitung Seite 51

5-2 Mechanical Adjustment
5-2-1 Tape Transport System and Adjustment Locations
The tape transport system has been adjusted precisely in the factory. Alignment is not necessary except for the
following :
1) Noise observed on the screen.
2) Tape damage.
3) Parts replacement in the tape transport system.
Lower flange height of tape guide is used as the reference for the transport adjustment.
To maintain the height of the tape guide and prevent damage, do not apply excessive force onto the main base.
FULL ERASE HEAD
#3 GUIDE POST
TENSION POST
Toshiba
Downloaded from www.Manualslib.com
GUIDE ROLLER "S"
SUPPLY REEL DISK
Fig. 5-3 Location of Tape Transport Adjustment
FE HEAD
GUIDE ROLLER "S"
POST TENSION
#3 GUIDE POST
manuals search engine
CYLINDER ASS'Y
TILT SCREW
X - POSITION
ADJUST SILT
AZIMUTH SCREW
#8 GUIDE POST
CYLINDER ASS'Y
GUIDE ROLLER "T"
ACE HEAD
Fig. 5-4 Tape Travel Diagram
Alignment and Adjustment
GUIDE ROLLER "T"
HEIGHT SCREW
PINCH ROLLER
#9 GUIDE POST
CAPSTAN
TAKE UP REEL DISK
PINCH ROLLER
#8 GUIDE POST #9 GUIDE POST
MAIN BASE
CAPSTAN SHAFT
5-3