Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Guided Tour - R32 Rear Panel
1: DC input - Connect the supplied 12 volt 220 mA power adapter here, using the strain
relief as shown in the illustration below. WARNING: Do not substitute any other kind of
power adapter; doing so can cause severe damage to the R32 and will void your warranty.
2: Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when
connecting the R32 to consumer (-10) audio equipment. Wiring is as follows: tip hot,
sleeve ground.
3: Audio Output Level switch - Sets the audio output level attenuation of the balanced
output (see #4 below) to -20 dBm (line level) or -40 dBm (mic level). See the "Setting Up
and Using the Synth 32 System" section on page 12 in this manual for more information.
4: Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR
jack when connecting the R32 to professional (+4) audio equipment. Pin wiring is as
follows: Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).
* If required, both the unbalanced and balanced outputs can be used simultaneously.
Downloaded from
www.Manualslib.com
DC INPUT
UNBALANCED
CAUTION
OUTPUT
THIS DEVICE COMPLIES WITH PART
15 OF THE FCC RULES.
OPERATING IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS
(1) THIS DEVICE MUST NOT CAUSE
HARMFUL INTERFERENCE AND
-10dB 5KΩ
(2)THIS DEVICE MUST ACCEPT
ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT
CAUTION:
MAY CAUSE UNDESIRED OPERATION
USE SAMSON
DC 12V, 2.7W(220mA)
AC ADAPTER
AC250 ONLY
1
2
Using the strain relief: Gather up a loop of wire and pass it through the strain relief,
then pass the adapter plug through the loop in order to create a knot.
manuals search engine
BALANCED
BALANCED
SWITCH
OUTPUT
MIC
LINE
-40dBm
-20dBm
600Ω
600Ω
XLR:
1
GND
POWER RATING
2
HOT
3
COLD
3
4
8
RECEIVER MODEL R32M
FCC ID:CCRR32M
SAMSON
Technologies Corp.
Werbung
Inhaltsverzeichnis
