Samson UHF Synth 32 Bedienungsanleitung Seite 12

Guided Tour - H32
Downloaded from www.Manualslib.com manuals search engine
5: Battery holder - Insert a standard
9-volt alkaline battery here, being sure to
observe the plus and minus polarity
markings shown. We recommend the
Duracell MN 1604 type battery. Although
rechargeable Ni-Cad batteries can be
used, they do not supply adequate current
for more than four hours.
WARNING: Do not insert the battery
backwards; doing so can cause severe
damage to the H32 and will void your
warranty.
Note: As shown in the illustration on the
left, the controls for setting the H32 Group
and Channel indicated below are located
on the opposite side to the battery
compartment:
6: Group selector - Use the supplied
plastic screwdriver to set this to the
desired transmission frequency Group.
7: Channel selector - Use the supplied
plastic screwdriver to set this to the
desired Channel. When two or more
transmitters and receivers are being used
7
in the same location, they should be set up
to use different Channels within the same
6
Group—see the "Setting Up and Using the
Synth 32 System" section on page 11 and
Appendix B on page 54 in this manual for
more information.
12