Troubleshooting; Solving The Problem - TerraTec SUBSeSSion Handbuch

Troubleshooting

Solving the problem

These are some of the most likely reasons for problems you might have with SubSession.
Please make sure you go through them before contacting technical support.
I can't get any sound.
Make sure that the amplifier and audio source are:
• switched on.
• connected properly.
• producing sound. Try listening through headphones to confirm this. If not, make sure the
volume is not set to zero.
If you have connected SubSession to a PC sound card, make sure the Windows volume control
isn't set to mute, by double-clicking the speaker icon on your Windows taskbar.
Make sure all the cables are properly connected.
The sound has too much or too little bass.
Try adjusting the Sub control on the amplifier.
If your audio source has tone controls, set them to neutral.
If you have too little bass, make sure the bass reflex port (the hole at the front of the subwoo-
fer) isn't obscured.
Make sure the subwoofer and satellites are properly connected.
There is sound, but it is very quiet.
Make sure the Volume control on the amplifier isn't set too low.
If your audio source has a volume control, make sure it isn't set too low.
Make sure the audio source is properly connected.
If you have connected SubSession to a PC sound card, make sure the Windows volume control
isn't set too low, by double-clicking the speaker icon on your Windows taskbar.
Make sure you have wired the satellites the right way up, so that the high range sockets on
the satellites are connected to the high range sockets on the amplifier, and the same for the
low range sockets.
SpeakerMaster SubSession 23
Downloaded from www.Manualslib.com manuals search engine