Operating Instructions - AGFA Rapiline 51 Serie Benutzerhandbuch

OPERATING INSTRUCTIONS

Only Off line processors
The processor can be used either as a
daylight loading processor where the take-
up cassette is placed in the light-proof daylight
loading cassette or as a "table feed" proces-
sor installed in a darkroom.
DAYLIGHT LOADING CASSETTE
1) Open the daylight loading cassette.
2) Adjust the heigth of the cassette shelf.
3) Place the take-up cassette in the daylight
cassette with approximately 15 cm material
pullled out of the take-up cassette.
4) Feed the front edge of the material under
one of the sensors into the feed slot between
the input transport rollers.
5) Close the daylight loading cassette.
6) The processor will start its operating mode
and the material will be pulled out of the take-
up cassette.
A light diode on the control panel will shine
as long as material is transported into the
developer rack. When the light diode stops
shining, the cassette can be opened and
new material can be inserted.
18.01.96
Downloaded from www.Manualslib.com manuals search engine
ROLL MATERIAL
Especially when using roll film/paper material,
it is most important that the front edge be cut
straight and at right angles to the transport
direction. To do this, use a cutter. Do not use
scissors.
Insertion must take place at right angles to
the insertion rollers and the material must be
prevented from moving sideways until the
transport rollers have a firm hold on the
material.
When using roll material (PTS-paper) the
front edge must always be folded as shown
on the sketch below
When processing PTS-film, a leader should
be used.
min. 4
cm.
User Manual
Page 13/16/GB