Toro Power Plex 51138 Bedienungsanleitung Seite 8

Setup
Note:
The battery pack is not fully charged when you
purchase it. Before using the tool for the first time,
refer to Charging the Battery Pack (page
Filling the Chain Saw with
Bar and Chain Oil
Important:
Use only bar and chain oil.
1. Place the chain saw on a level surface.
2. Clean the area around the oil cap
Note:
Make sure that you do not allow
debris/wood chips to enter the oil tank.
1. Oil cap
3. Remove the cap and pour oil into the chain saw
until the oil fills the window
Do not fill the chain saw higher than the bottom
of the fill neck.
4. Clean up any spilled oil and replace the oil cap.
Mounting the Battery
Charger (Optional)
If desired, mount the battery charger securely on a
wall using the wall-mount key holes on the back of
the charger.
Mount it indoors (such as a garage or other dry place),
near a power outlet, and out of the reach of children.
Refer to Figure 2 for assistance in mounting the
charger.
Note:
Slide and twist the charger over the
appropriately positioned hardware to secure the
charger in place (hardware not included).
15).
(Figure
Figure 1
2. Oil window
(Figure 1).
1).
g192110
7
Figure 2
g194202