Datalogic Magellan 2300HS Schnellreferenzhandbuch Seite 9

Volume/Tone Push Button
Table 1. Volume/Tone Push Button Functions
PRESS
DURATION
Momentary (when
scanner is asleep)
Momentary (when
scanner is awake)
Hold, then release
when the beeper
sounds
4 Seconds
8 Seconds
a. By standard default, this function is normally disabled to prevent accidental activation by users.
b. Users should not perform scanner resets except under the direction of trained systems support person-
nel.
Quick Reference Guide
Downloaded from www.Manualslib.com
The Volume/Tone Push Button (
Cover c) also performs multiple functions depending upon the duration
Figure 2
of time it is pressed:
Volume changes made using the Volume/Tone Push Button are lost
when the scanner is powered-down and are reset to the configured set-
ting. If you wish to permanently change the volume, use the special
programming labels in the Product Reference Guide.
NOTE
FUNCTION
Wakes scanner from Sleep
Mode
Increments volume
Increments tone
Scanner Diagnostics Mode
b
Resets Scanner
manuals search engine
d — accessed by removing the Top
Figure 2
Alternatively, the scanner can be awakened by:
- Moving an object through the scan zone.
- Scanning with an attached auxiliary scanner.
Press the push button momentarily to increase speaker vol-
ume. When the loudest volume is reached, a repeated press
of the push button cycles volume back to the lowest setting,
then volume increases on subsequent press(es). Four volume
levels are available.
Press the push button for approximately 2 seconds, then
release. Each time this is done, the beeper will sound at one
of three tones. Stop when the desired tone (high, medium or
low) is sounded.
This mode allows system support personnel to troubleshoot
problems with the scanner and is used to determine if it can
a
read bar codes. Press the button for eight seconds or cycle
power to exit Scanner Diagnostics Mode and reset the scan-
ner.
Only system support personnel should perform a reset.
COMMENT
3