Schumacher 12V-2A Betriebsanleitung Seite 2

2. Control Panel
START/STOP BUTTON
Press to immediately start charging your properly connected booster. If the button is not pressed, charging
should begin in ten minute's time.
POWER LED (green)
The charger is connected to an AC outlet.
Charging LED (yellow/orange)lit
The battery is charging.
Charging LED (yellow/orange) flashing
The battery is not charging because the charger has detected a problem. The "defect" LED will also light up
(refer to point 5 "Troubleshooting").
Charged/Maintaining LED – GREEN pulsing
The battery is fully charged. The charger gets in float charging mode to maintain the battery capacity.
Battery Defect LED (red)
The charger has detected a problem with the battery. These might be damaged or sulfated. In the above
case, please contact your retailer (refer to point 5 "Troubleshooting").
Reverse polarity LED
The charging circuit is in reverse polarity. Reverse the connections at the battery.
3. Specifications
Model
Voltage
Charging voltage
Charging current
Operating temperature
IP indication
Length of the DC cord
Check / Safety Mode
Reverse Polarity Protection
Protection against short-circuits
4. Operation Instructions
When you are sure that the charging plug is correctly connected, connect the power cord to the power
outlet and push the START/STOP button. If the latter is not pressed, charging should begin in then minute's
time. The charger starts and resets itself automatically. The charging LED's will indicate the charging
progress.
To disconnect the charger from your battery, push the START/STOP button. Remove the AC cord from the
electric outlet and disconnect the charger from the battery.
845122-A-Manual-R0-20161020
Charger 12V-2A
220~240V AC 50/60Hz, 0.5A
12V (nominal) / 14.7V (max.)
2A
-20° to +50°C
IP20
+- 160 cm
2