HP 3Com IntelliJack NJ2000G Kurzanleitung Seite 5

Observe All Safety Precautions
This equipment must be installed in compliance with local and national
building codes, regulatory restrictions, and FCC rules. See the section
"Regulatory Notices" at the end of this guide. For the safety of people and
equipment, only professional network personnel should install the
NJ2000G.
WARNING: To avoid possible injury or damage to equipment, you must
use power supply equipment that is safety certified according to UL, CSA,
IEC, or other applicable national or international safety requirements for
the country of use. All references to power supply in this document refer to
equipment meeting these requirements.
Check the Shipment
The NJ2000G is available in single- and 20-unit packs. Make sure that you
have the following items, which are included with each NJ2000G:
NJ2000G
•
Screw kit for wall mounting the NJ2000G
•
Male-to-male RJ-45 coupler cables (2 per NJ2000G) for connecting the
•
Ethernet cable from the network to the NJ2000G. NOTE: For use only if
the network cable is terminated with a female RJ-45 connector.
The following optional items may be useful, depending on your specific
installation requirements and the PoE capability of your network. If you
choose to use any of these items, be sure that they are on hand before
you begin the installation.
Part Number
3CNJ1000PSE
3CNJ1000PSL
3CNJ1000STAND Optional desk stand
Description
Optional mid-span
power injector
Optional local power
supply
Purpose and 3C (Ordering) Numbers
For providing 802.3at PoE to an NJ1000 or NJ2000G
For locally powering a single NJ1000 or NJ2000G
NOTE: This item is required if the network does not
support Power over Ethernet.
For mounting the NJ1000 or NJ2000G on the
desktop
5