HP 3Com IntelliJack NJ2000G Kurzanleitung Seite 13

12. Download and Install the 3Detect Software (Optional)
To simplify discovery of the NJ2000G on the network:
Turn your computer on, launch your web browser, and point to
1
www.HP.com
Select Support > Downloads & Drivers. To locate and download the
2
3Detect software, enter 3CNJ2000G and then select Utility
Download and expand the software, and then run setup.exe
3
Follow the instructions on the screen to complete the installation.
4
Using 3Detect Software
With the HP 3Detect software, you can discover the NJ2000Gs on a
subnetwork and determine their IP addresses. Follow these steps:
1
Connect your computer to the NJ2000G either directly or over the network.
2
Launch 3Detect from the Windows Start menu:
Start > Programs : HP 3Detect > 3Detect
When 3Detect discovers your NJ2000G, it displays it on the main screen.
3
Select your NJ2000G in the list and then click Properties. Make a note of the IP address.
4
Repeat the process for each NJ2000G in the network.
13. Troubleshooting: Check the LEDs
Verify the NJ2000G installation by checking the LEDs according to this table:
LED
LAN
Port 1 and Port 2
PoE
Uplink
PoE Power LED:
DC Power LED:
Description
On — A device is connected to the NJ2000G and a link has been
established. Off — There is no connection to the NJ2000G.
On — 802.3af PoE is being supplied.
Off — No PoE is being supplied.
On — The unit is connected to the network and a link has been established.
Off — There is no connection to the network.
On — The unit is receiving power via PoE from the network.
Green — Power is supplied via 802.3at
•
Amber — Power is supplied via 802.3af
•
Off — The NJ2000G is not receiving PoE power.
On — The unit is receiving power via the optional local DC power supply,
3CNJPSL.
Off — The NJ2000G is not receiving local DC power.
Software.
13