Makita DG001G Betriebsanleitung Seite 5

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
No load speed
Drilling capacities
(Diameter)
Overall length
Rated voltage
Net weight
*1. With side handle and battery cartridge BL4040.
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Recommended battery adapter and cord connected battery pack
Battery adapter
Cord connected battery pack
• The battery adapter(s) and cord connected battery pack(s) listed above may not be available depending on
your region of residence.
• Before using the battery adapter and cord connected battery pack, read instruction and cautionary markings on
them.
Intended use
The tool is intended for drilling the ground.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-1:
Sound pressure level (L
Sound power level (L ) : 95 dB (A)
WA
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
High
Low
) : 84 dB(A)
pA
For sandy soil: ø200 mm
For clay soil: ø150 mm
D.C. 36 V - 40 V max
BL4020 / BL4025* / BL4040* / BL4050F*
* : Recommended battery
DC40RA / DC40RB / DC40RC
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the tool is
used especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (tak-
ing account of all parts of the operating cycle such
as the times when the tool is switched off and when
it is running idle in addition to the trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-1:
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
5 ENGLISH
DG001G
-1
0 - 1,500 min
-1
0 - 400 min
842 mm *1
7.2 - 8.1 kg
PDC01
PDC1200
2
) : 2.5 m/s or less
h,D
2