Interconnections - Sony SDX-S300C Bedienungsanleitung

Interconnections

10
Part 2 Preparation
Up to fifteen Wide SCSI peripherals can be connected to the host computer
through the SCSI bus.
Use a regular Wide SCSI cable for connection. The drive uses a 68-pin half-
pitch connector.
Precautions
• Switch off the host computer and peripherals before connecting the Wide
SCSI cable.
• Make sure the Wide SCSI connectors are pressed tightly together.
• If the drive is the last (or only) device on the Wide SCSI bus, be sure to
connect a SCSI bus terminator to the unused SCSI connector.
Use a single ended terminator for SDX-S300C or a differential terminator
for SDX-S310C.
Use of the wrong terminator may cause damage.
• The total length of the SCSI cable(s) between the host computer and the last
device on the SCSI bus should be less than 3 meters (SDX-S300C) or 25
meters (SDX-S310C).
SCSI CONNECTOR
SCSI ID
0
FG
Terminator
AC IN
AC Power