Sony CFD-360 Bedienungsanleitung Seite 20

Waking up to music (continued)
Tip
You can have the
player go on the next
day at the same time.
Just press STANDBY
until the t indication
appears in the display.
The preset settings
remain until you reset
them.
Note
"TIMER" disappears
from the display and
the timer mode is
canceled if you press
9 button of the tape
player while music
plays in the timer
mode.
EN
20
The Timer
CFD-360.E.G_3-000-000-1X.CED/CEE/CEK/EE1
7
Press STANDBY.
The t indication lights up and the power goes off.
At the preset time, the power will go on, "TIMER"
appears in the display and music will play, and
will shut off automatically after about 60 minutes.
To check/change when the playback will start
Press CLOCK/TIMER, then DISPLAY/ENTER. Each
time you press DISPLAY/ENTER, a stored setting
lights up. Change the setting if you need to when the
setting lights up. When you finish checking, press
CLOCK/TIMER again.
To use the player before a timer playback starts
Just turn on the player, and then you can use it.
If you turn off the player before the preset time, timer
playback will start at the preset time.
In case of the radio, however, if you listen to the
station which is different from the one you tuned in
in step 1 on page 19, you will hear that station at the
preset time. Make sure to tune in the station you want
to listen to before you turn off the player.
To stop play
Press POWER.