Troubleshooting - Hendi 230695 Gebrauchsanweisung

Troubleshooting

If the appliance does not function properly, please check the below table for the solution. If you are still
unable to solve the problem, please contact the supplier/service provider.
Problems
Machine does not
start running
Machine stops during
operation
Technical specification
Item no.: 230695, 230664
Operating voltage and frequency: 220-240V~ 50/60Hz
Rated input power: 1,680W
Protection class: class I
Waterproof protection class: IP23
Maximum capacity: 2,5L
Dimension: 252x258x(H)547mm
Remark: Technical specification is subjected to change without prior notification.
Possible causes
Protective cover (12) is not in properly
closed position.
Jug (9) is not placed properly.
Power switch (1) is not pressed
Built-in overloading device activates.
Possible solution
Check to make sure the protective cover (12)
is closed properly.
Check to make sure the jug set (9) properly.
Press the power switch (1)
- Switch OFF the machine by pressing the
switch (1) to STANDBY mode and unplug
the machine.
- Leaving the machine for cooling down for
about 30 minutes and then start again.
Net weight: approx. 9.7kg
Noise level: ≤ 85dB(A)
Rotation speed without loading (rpm):
- Low : 8,350 +/- 10%
- Medium: 13,500 +/- 10%
- High : 24,800 +/- 10%
Jar material: Tritan (230664), PC (230695)
EN
9