Operating The Cd-Player; Playing A Cd; Stopping Playback; Selecting A Track During Playback - T+A CD 820 M Betriebsanleitung

Operating the CD player – Basic functions
The CD 820 M can be controlled using the buttons on
the front panel or the M-system remote control handset.
To operate the machine, and to see messages on the
integral system screen (on the PT 820 M), you must first
select CD as the listening source:
• Press the   button on the F6 remote control
 
handset
or
• Press the   button on the front panel of the  
PT 820 M.
Inserting a CD
1. Press the 
the disc drawer.
2. Lay the disc in the centre of the appropriate recess in
the drawer, with the playable side facing down.
3. Press the 
the disc drawer.
As soon as the drawer closes, the player reads the
„Table of Contents" of the CD; the screen shows the
message ' READING READING READING READING
ignores any buttons you might press. Eventually the
screen displays the current mode of operation, the
number of tracks and the duration of the CD in the
drawer, e. g.:

Playing a CD

Briefly pressing the 
playback process. Playback commences, and the screen
displays the operating mode and the number of the track
currently playing:
At the end of the last track the CD stops, and the screen
again displays the message '
of tracks on the CD.
Variations
You can also start playing a CD by pressing the 
  buttons, even when the CD drawer is open, or by  
entering the track number directly using the numeric
buttons on the remote control handset.
The disc drawer closes automatically, and playback
commences with the first (or directly entered) track.
Downloaded from www.Manualslib.com
 button on the front panel to open  
 button on the front panel to close
 
'. During this period the machine
' STOP STOP 16 16 16 16 STOP STOP '.
  /    button starts the  
' PLAY PLAY 01 01 01 01 PLAY PLAY '.
STOP STOP STOP STOP ' and the total number
manuals search engine

Stopping playback

Briefly pressing the 
playback. The screen displays the message '
Briefly pressing the 
mode opens the CD drawer.

Selecting a track during playback

• Press the
repeatedly, or hold it pressed in, until the number of the
desired track appears on the screen after '
When you release the button, playback is interrupted
briefly, and the screen displays the message '
selected track is now played.

Numeric track selection

 
 
Numeric buttons
   
Numeric input for direct selection of a track
number.
 
 
When you press a numeric button (e. g. 1)
:
the screen shows the message:
:
 
 
   
For a period of about 3 seconds a marker
flashes. During this time you may
• press
complete a two-digit track number - the
machine
immediately.
• If you do not press a second button and
the 3-second period is over, the input is
assumed to be a single-digit track number
- the machine plays the selected track.
Note:
If you enter a track number which is not present on the
CD, the screen displays the message '

Fast search

• Fast search forwards
• Fast search backwards
  / 
24
 /   button stops
   
STOP STOP
STOP STOP
 /   button in STOP
   
    or   /      
JUMP JUMP JUMP JUMP
JUMP JUMP
JUMP JUMP
' SELECT _1 SELECT _1 SELECT _1 SELECT _1 '.
a second numeric button
plays the selected
ERROR ERROR ERROR ERROR '.
(hold the    button pressed in) 
(hold the   button pressed in)  
'.
button
'.
'. The
to
track