Routine Maintenance - Polaris Vac-Sweep 180 Bedienungsanleitung

Fine Tuning The Polaris Cleaner

Routine Maintenance

Downloaded from www.Manualslib.com
Pushes Unit Left
D place l unit vers la gauche
When operating correctly, the Polaris 180 vacuums, sweeps and scrubs all surfaces
Dr ckt Ger t Nach Links
randomly throughout the pool. Approximately every 3 minutes the Polaris 180 goes into
Empuja la unidad hacia la izquierda
back-up mode. This action pulls the Polaris away from pool obstacles and increases its
Spinge l unit a sinistra
Empurra a unidade para a esquerda
random pattern.
Thrust Jet Adjustment
Pushes Unit Right
The thrust jet powers the direction of the Polaris.
D place l unit vers la droite
Factory position is straight back, but depending Dr ckt Ger t nach rechts
Empuja la unidad hacia la derecha
on the pool, other settings are helpful.
Spinge l unit a destra
Empurra a unidade para a direita
Sweep Hose Adjustment
The sweep hose should move in a gentle sweeping
Increases Climbing
motion. To adjust, turn off the booster pump and turn
Augmente la force de grimpe
the sweep hose adjustment screw. Turn clockwise to
Erh ht Steigung
decrease the motion.
Aumenta la ascensi n
Aumenta la salita
Aumenta a subida
Decreases Climbing
Diminue la force de grimpe
Cleaning the Filter Bag
Verringert Steigung
Disminuye la ascensi n
Diminuisce la salita
Remove the bag from the cleaner. Open the bag closure and dump out the debris.
Diminui a subida
Empty the filter bag
when it is half full,
especially if the dirt
load is sand.
It is easier to empty
the bag when it is dry.
Alternate between
two bags.
Backwashing the Pool Filter
Always disconnect the Polaris from the pool wall before cleaning or backwashing the pool
filter. After cleaning or backwashing, let the filtration system run for at least five minutes to
flush out the return lines before re-connecting the Polaris.
Storage and Winterizing
Never store the Polaris in direct sunlight. When storing for the winter, drain out all the water
(freeze damage is not covered under the warranty). Remove the UWF from the pool wall by
attaching the Quick Disconnect and using pulling pressure to unscrew. In some cases, it may
be necessary to use the UWF Removal Tool (part #10-102-00) available from an authorized
Polaris dealer.
For on-line support: www.polarispool.com
manuals search engine
12
9 3
6
Velcro
Closure