Radio Operation - Xomax XM-2CD613 Anleitung

1. Choose Radio Band
Press the BND/SUB Button anytime
to access the radio function.
The unit comes with five bands- three
FM Bands (FM1, FM, and FM3)
and two AM Bands (AM1, and AM)
selects. Each of the five bands can
store up to six preset stations, for a
total of 30 preset memory stations.
NOTE: To change the receiving range
from USA to Europe remove the face-
plate and then move switch marked
"A-E" to the appriate region.
2. Radio Tune / Seek Function
In Radio Mode, press Seek +/- But-
ton to manually adjust the radio fre-
quency.
3. Tuning
Press the SEEK |<< or >>| Button
once and the radio will change by one
station.
Press and hold the SEEK |<< or >>|
Button for  seconds and the radio
will seek the next strong and clear fre-
quency station. Repeat to seek more
stations in your listening area with a
strong signal.
4. Mono/Stereo Reception Control
In FM radio mode, press the SEL but-
ton repeatedly until the display shows
"ST ON" or "ST OFF"(MONO). Turn
the volume knob to change between
ON or OFF. Improvement of reception
of distant stations can be done by se-
lecting "ST OFF (MONO)" operation
which may cut down some reception
noise.
5. Save Your Preset Stations
There are six numbered preset but-
tons which can store and recall sta-
tions for each band. While listening to
a radio station you would like to save
as a pre-set, press and hold one of the
buttons numbered 1- until you hear a
beep. The button you pressed is now
the pre-set button for that station.
Downloaded from www.Manualslib.com manuals search engine

Radio Operation

6. Automatic Store/Preset Scan
There are six numbered preset but-
tons which can store and recall sta-
tions for each band. While listening to
a radio station you would like to save
as a pre-set, press and hold one of the
buttons numbered 1- until you hear a
beep. The button you pressed is now
the pre-set button for that station.
A. Automatic Scan & Store
While listening to the FM Radio, press
and hold the F/PS Button. The receiv-
er will automatically scan and save
stations of the 3 FM Bands.
While listening to the MW Radio,
press and hold the F/PS Button. The
receiver will automatically scan and
save stations of the  MW Bands.
While listening to the LW Radio, press
and hold the F/PS Button. The receiv-
er will automatically scan and save
stations for the LW Band.
B. Scan & Preview Saved Stations
Press the F/PS button once and the
receiver will scan the radio stations in
the current band.
Owner' Manual
13