Tools For Installation - Xomax XM-2CD613 Anleitung

Car multimedia system am/fm receiver, cd/mp3/wma player with electronic antishock (esp) & detachable face rds/eon control, usb and sd card control

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

Warnings Before Installation

for details on connecting the power amp and other units, then make

the connections correctly.

• Do not block any vents or heater panels. Blocking them will cause

heat to build up and may result in fire.

• Make sure that the unit has a good chassis ground. A good ground

connection will eliminate most electrical noise. A good chassis

ground requires a tight connection to the vehicles metal chassis.

The area around the ground connection should be clean, bare metal

without rust, paint, plastic or dirt for a good electrical connection.

• If noise is still experienced when the motor of the vehicle acceler-

ates, a choke should be placed in line with the power to the unit. The

installation company will know what is required.

• When replacing the fuse(s) the replacement must be of the same

amperage as shown on the fuse holder. Never replace a fuse with

another of a different value. If the fuse blows again please contact

your installation company.

• Do not block vents or heater panels. Blocking them will cause heat

to build up inside and may result in fire.

• Double check that all wiring and connections are correct before re-

connecting the battery and turning on the unit.

• After completing the installation and before operating the unit, recon-

nect the battery, Then press the (RES) button with a pointed object,

such as a ball-point pen to set the unit to its initial status. After push-

ing the button, wait a few seconds for the red light to flash.