Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Basic Operation
1. Tuning the unit On / Off
Press any Button to turn the unit
on, the display will show a message
WELCOME to indicate it is ready for
use. Press the PWR button for 3 sec-
onds to turn the unit off. The display
will show a message "GOODBYE".
2. Mode Selection
Press the BND/SUB Button to select
Radio Mode. Press the MOD Button
to cycle the Play Mode amoung AUX,
RADIO and CD PLAY.
Note: USB mode will only show on the
display when a USB flash memory is
inserted into the USB port.
3. Loudness Control
Press the SEL button until "LOUD
OFF" is shown on the display indi-
cates that the loudness function is
OFF. Turn the volume knob to select
between ON or OFF.
4. Subwoofer Control
Press and hold the the BND/SUB
Button to turn the subwoofer output
ON. Make sure the unit has an ex-
ternal amplifier installed to drive the
subwoofer.
5. Mute Control
Press the Mute Button on the front
panel to activate the Mute function.
Press the Button again or use the
VOL +/ - Button to cancel.
6. Volume
Use the VOL +/- Button to adjust the
volume level. The larger the number,
the higher the volume level.
7. Bass
Press the SEL Button repeatedly un-
til the display shows "BAS". Use the
VOL +/- Button to adjust. When EQ is
ON, bass control is not available.
8. Treble
Press SEL Button repeatedly until the
display shows "TRE". Use the VOL
+/- Button to adjust. When EQ is ON,
treble control is not available.
Owner' Manual
1
Downloaded from
www.Manualslib.com
manuals search engine
9. Balance
Press SEL Button repeatedly until the
display shows "BAL", then use the
VOL +/- Button to adjust the balance
between the left & right speakers.
10. Fader
Press SEL Button repeatedly until the
display shows "FAD", then use the
VOL +/- Button to adjust the balance
between the front & rear speakers.
11. Clock
The time clock can be set anytime
when the power is on. Press the PTY/
CLK Button on the faceplate or remote
control once (press and hold for more
than seconds during radio mode),
the time will show on the display.
Then press and hold the button until
the hour blinks on the display. Rotate
the VOL knob to set hours, then press
the VOL knob for the minutes to blink
and rotate the VOL knob to set.
Press the PTY/CLK button again or
leave the unit idle for new setting to
effect. Press the PTY/CLK button any-
time to view the time clock display.
12. Preset Beep Sound Off
Press the SEL button repeatedly un-
til "BEEP ON" is displayed. Turn the
VOL +/- Button to select "BEEP OFF"
or "BEEP ON", then leave the unit idle
for setting to take effect.
13. Preset Equalizer Function
Press the SEL Button repeatedly until
"EQ" indication is displayed then ro-
tate the Volume knob to choose be-
tween the EQ sound effects.
14. Dual Color Select
Press the SEL knob repeatedly until
the display shows "Color 1" or "Color
" Turn the volume knob to select be-
tween "Color 1" or "Color " .
Werbung
Inhaltsverzeichnis
