Setting Current Date And Time (24 Hour Clock) - Mitsubishi Electric PV-PNS03ATL-GER Bedienungsanleitung

5.3.3 Setting Current Date and Time (24 Hour Clock)

1
2
3
4
Downloaded from www.Manualslib.com
Display panel
SETUP
DA E / T T ME I
T I ME 1 5 : 2 1 : 3 4
2 5 AUG 2 0 0 6
Flashing
T I ME 1 5 : 2 1 : 3 4
2 5 AUG 2 0 1 6
Flashing
T I ME 1 5 : 2 1 : 3 4
2 5 AUG 2 0 0 6
Flashing
SETUP
DA E / T T ME I
manuals search engine
Procedure
Press the MODE switch several times
until the "SETUP" mode is displayed.
・"SETUP" is displayed in the upper left-
hand side of the LCD. "DATE/TIME" is
displayed on the lower row, telling you
are in the date/time setting mode.
Press the ENTER switch.
・The PV inverter becomes ready to
accept settings. "Hour, minute, sec-
ond" and "day, month, and year"
currently registered on the PV
inverter is displayed. The denary
digit starts flashing.
1. Each push of the SELECT switch will
switch the number of the denary digit:
→ 1 → 2 → ...9 → 0
Select the number you want to set on the PV inverter.
2. Press the MODE switch.
・Now the first digit starts flashing (where
you will set the desired number).
Then repeat the same procedure with the
MODE switch to choose the digit you wish
to set, causing it to flash. Press the
SELECT switch to bring up the number cor-
responding to the desired date and time.
Press the ENTER switch to register
the date and time you have just set.
(The PV inverter reverts to step 1
above.)
73
pp.1-48
pp.1-48
pp.1-48