Troubleshooting - Team Orion Advantage IQ404 Bedienungsanleitung

5. Connect the battery to the charger using its power connector and its bal-
ancing connector (JST-XH type). The control LED lit red according to the
number of cells. If the LED is flashing red it indicates a problem with the
wiring or the battery. Check the connections or discontinue use of this bat-
tery immediately if it is defective.
6. When the battery is fully charged, all the control LED will lit green.
Depending on the charge state of the battery and its capacity, it can take a
long time before all the LED become green.

Troubleshooting

• If the charge does not start, make sure all connectors are plugged in, that
the polarities are correct and that the battery is functional.
• If the LED flash red, check that the connections are correct and that the bat-
tery is functional.
• If some LED lit green at the end of the charge and others remain red, it
means that the charger is balancing the battery.
Warnings
• This charger is designed to charge only 2 to 4 cell LiPo batteries.
• Make sure that the charger's charge rate is compatible with the battery.
• You cannot adjust the charge current when the battery is connected to the
charger.
• Never leave the charger unsupervised while it is powered on.
• Never let children operate the charger without supervision from an adult.
• The charger is for indoor use only. Do not use in case of high humidity or
condensation.
• Do not attempt to open or modify the charger's case.
4
Downloaded from www.Manualslib.com manuals search engine
Team Orion Advantage IQ404