Connecting Cables Through The Housing Base; Connecting Cables Through The Side Conduit - Honeywell HD4VC4HR Benutzerhandbuch

Connecting Cables Through the Housing Base

For installations requiring pulling cables through the grommet located in the bottom of the
base:
1. Use a sharp knife to cut an
careful. The opening should only be big enough to feed the cable assembly through.
2. Pull the cabling through the opening.
3. Apply appropriate sealant around the opening to prevent moisture from entering the
housing.

Connecting Cables Through the Side Conduit

1. Peel back the bottom flat gasket below the side conduit just enough to expose the security
screw.
2. Use the Allen key supplied to loosen and remove the security screw.
3. Use a flat screwdriver to unscrew the conduit plug.
4. Pull the cabling through the hole.
5. Apply appropriate sealant around the opening to prevent moisture from entering the
housing.
Rev 1.02
opening in the base gasket (see the figure below). Be
4
Base gasket opening
Document 900.0556
01/06