Maintenance; Error Indicators And Warnings; Specifications; Sound Bar - Sharp HT-SB602 Bedienungsanleitung

Maintenance

„ Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth.
Caution:
z Do not use chemicals for cleaning (petrol, paint thin-
ner, etc.). It may damage the cabinet finish.
z Do not apply oil to the inside of each component. It
may cause malfunctions.

Error indicators and warnings

When you fail to perform operations properly, the follow-
ing messages are displayed on the sound bar.
Display
z When there is no input signal.
z Nonstandard signal. Cannot
z Signals other than DOLBY
(Display blinks)
z Poor connection of the digital
z Turn off the sound bar
z When the protection circuit is
Error indicator
(blinks red)
(*): Should the same message appear even if the
speaker is unplugged and plugged in, or is set to
the standby mode and on again, contact your local
dealer where you purchased the sound bar.

Specifications

As part of our policy of continuous improvement, SHARP
reserves the right to make design and specification
changes for product improvement without prior notice.
The performance specification figures indicated are
nominal values of production unit. There maybe some
deviations from these values in individual unit.
„ Sound Bar
Power source AC 220 - 240 V ~ 50/60 Hz
Power Power on: 38 W
consumption
Power standby: 0.4 W (*1)
Power standby: < 6 W (*2)
Dimension Width: 1386 mm
Height: 74 mm
Depth: 68 mm
Weight 3.7 kg
Output power RMS: Total 160 watts
RMS: 160 W
(80 W + 80 W) (10% T.H.D.)
RMS: 120 W
(60 W + 60 W) (1% T.H.D.)
All manuals and user guides at all-guides.com
Meaning
Play back the connected
equipment.
be recognized.
DIGITAL, DTS, Linear PCM
cannot be recognized.
audio input terminal.
and check if the cable is
connected properly.
activated.
Output HDMI™ output: (audio/video support
terminal up to 1080p) x 1
Input terminal 500 mV / 47 kohms
Optical digital input (OPTICAL):
Square type x 1
HDMI input: (audio/video support up
to 1080p) x 2
Type 2 Way speaker system
5.7 cm woofer
2.5 cm Soft Dome
Bluetooth 2.400GHz - 2.480GHz
Frequency
band
Compatible A2DP (Advanced Audio Distribution
Bluetooth Profile), AVRCP (Audio/Video
Profile Remote Control Profile)
Bluetooth 2.1 +EDR
Maximum 160 W
input power
Rated input 80 W
power
Impedance 4 ohms
(*1): This power consumption value is obtained when the
sound bar is in low power consumption mode.
(*2): This power consumption value is obtained in the STANDBY
mode.
„ Subwoofer
Power source AC 220 - 240 V ~ 50/60 Hz
Power Power on: 33 W
consumption Power standby: 0.4 W (*1)
Power standby: 0.4 W (*2)
Output power RMS: 150 W (10% T.H.D.)
RMS: 120 W (1% T.H.D.)
Type Subwoofer system
16 cm woofer
Maximum 300 W
input power
Rated input 150 W
power
Impedance 3 ohms
Dimensions Width: 144 mm
Height: 432 mm
Depth: 306 mm
Weight 6.1 kg
E-18