Pulsar AXION LRF XQ38 Erste Schritte Seite 7

Installing Battery Pack
• Put the lock-cover
• Insert the rechargeable battery
compartment (19).
(11)
• Lock the battery
• Turn the lock-cover
Using a built-in laser range nder
The Axion LRF XQ thermal imager is equipped with an integrated laser
rangefinder.
Single Measurement Mode
• Press the ON/OFF
• Activate the rangefinder by pressing
(2)
the DOWN button briefly. A red mark
appears on the display.
• Place the rangefinder's reticle on the
target. Press the DOWN
measure the distance to the object once.
• The measurement results are displayed in
the upper right corner.
• The rangefinder shuts down after 3 seconds
of inactivity.
Scan Mode
• Press the ON/OFF
• Activate the rangefinder by pressing the DOWN
appears on the display.
• Activate the scan mode by long pressing the DOWN
measure the distance to objects.
• The measurement results are displayed in the upper right corner.
• Deactivate the rangefinder by long pressing the DOWN
• Additional rangefinder settings are available in the LRF section of the main
menu.
(18) on the rechargeable battery (11).
(11)
along the guide into the battery
by turning the lock-cover
(11) counterclockwise to remove the batteries (18).
(5)
button briefly to power the device on.
(2)
button briefly to
(5)
button briefly to power the device on.
(18)
clockwise until it stops.
(2)
button briefly. A red mark
(2)
button to continuously
(2)
button.
4
ENGLISH