Troubleshooting; Technical Specifications - Kasanova LEI002696NOC Bedienungsanleitung

KETTLE WITH THERMOMETER
14
3. Pour over 0.5 liters of water to the kettle and let it boil, then sprinkle 25
grams of citric acid, let stand for 15 minutes and finally rinse the kettle with
clean water 4 to 5 times.

TROUBLESHOOTING

Fault
Auto shut-off before
water boiling
Kettle does not work
The water in the
kettle has a strange
smell
Inside the kettle
water is dirty and you
can see the scale.

TECHNICAL SPECIFICATIONS

Rated voltage: 220-240 V
Rated power: 1850-2200 W
Rated frequency: 50/60 Hz
Capacity: 1.8 l
The reason for the fault and how to remove it
.1. This problem is usually due to the presence of scale in the kettle, so it
can be solved by eliminating the scale.
2. This problem may be caused by inadequate amount of water in the
kettle or the inclusion of an empty kettle, which triggers the kettle pro-
tection against running dry. In order to reset the device again, pour cold
water into the kettle; reset the protection after approximately 2 minutes;
then you can restart the kettle.
1. Make sure the plug is properly inserted into the socket and that the
2. If the power cord is damaged, it must be replaced by the maintenance
department of the manufacturer.
3. If you run the kettle without water protection device, it cuts off the
1. This problem usually occurs when the kettle is used for the first time.
In order to solve this problem, proceed in accordance with section 6.
2. If the problem persists, fill the kettle with water up to the maximum
level, add two tablespoons of baking soda, and after boiling empty the
Due to the hard water, a precipitate forms in the form of calcium carbon-
ate and magnesium carbonate. Just regularly decalcify the kettle.
socket is working.
power supply.
kettle.