Hama Triton Bedienungsanleitung Seite 5

3. Cable Remote Control Functions
3
3.1 Volume (1): increases or decreases the volume
Microphone (2): switches the microphone on/off.
Even if the microphone is switched off, you can still
hear your own voice.
No voice is communicated to the caller, however.
On/Off (3): switches the headset on/off.
4. Specifi cations
Speakers:
• Output: max. 600 mW
• Frequency range:
• 20 Hz - 20 kHz (front speaker)
• 50 Hz - 20 kHz (rear and central speakers)
• Sensitivity:
• 118dB +/-3dB (front speaker)
• -115dB +/-3dB (rear and central speakers)
• Impedance:
• 64 Ohm (front speaker)
• 32 Ohm (rear and central speakers)
Microphone:
• Frequency range: 30 Hz - 16 kHz
• Sensitivity: 60 dB +/- 2 dB
• Impedance: 2.2 kohm
5. Safety instructions
Do not use the device in moist or extremely dusty areas,
on radiators or in the vicinity of heat sources.
This device is not designed for use outdoors.
Protect the device from pressure and impact.
Only qualifi ed professionals may open the device for
maintenance purposes.
8
Downloaded from www.Manualslib.com
Protect the device from splashes of water and direct
sunlight.
Clean the ear piece surfaces using a soft, dry cloth.
1
2
6. Troubleshooting:
No sound playback.
In the control panel, check that your operating system
has recognised the headset as a standard audio device.
To do so, select „Start -> Settings -> Control Panel ->
Sound and Audio Devices" and choose the respective
device for the sound playback and output. This is usually
„C-Media USB Sound Device".
6.1 Important:
• Do not remove the USB headset from the USB port on
your PC if the red LED is illuminated on the cable
remote control. First, close all programs for media
playback and end all microphone functions.
• If you are using other USB devices at the same time
as the USB headset, you should disconnect the USB
headset before removing the other devices. These
steps ensure optimum headset functionality.
• If you are operating the headset and a USB webcam
simultaneously, reduce the bandwidth of the webcam
to the minimum. Do this by selecting the corresponding
option in your webcam software.
manuals search engine
6.2 Recommended settings:
To ensure optimum sound quality, we recommend that
you apply the following settings as default.
Select the 6-channel output on the „Main Settings" tab
page.
Activate the bass boost by clicking the „hammer symbol"
next to the symbol for 6-channel output.
Perform the following settings in the right window using
the symbol:
L/R = +10dB, C = +13dB, Ls/Lr = +18dB, Subwoofer =
+21dB
7. Support and Contact Information
If the product is defective:
Please contact your dealer or Hama Product Consulting if
you have any product claims.
Internet / World Wide Web:
Product support, new drivers and product information
can be found at www.hama.com.
Support hotline – Hama product consultation:
Tel. +49 (0) 9091 502 115
Fax +49 (0) 9091 502 272
E-mail: produktberatung@hama.de
9