Voice Command - Sena SRL2 Benutzerhandbuch

11 VOICE COMMAND

The voice command of the SRL2 allows you to operate certain
operations by simply using your voice. You can control the SRL2
completely handsfree using the voice recognition. The voice command
function works only with English commands.
Voice Command Procedure:
1. There are two ways to enter the voice command mode. The
simplest way is to tap the Center Button and the (-) Button
simultaneously. Another way is to say, "Hello Sena" during stand-
by mode.
2. Speak a voice command from the table below:
Mode Status Function
Start/End each intercom
End all intercoms
Call last intercom
Standby/Intercom
Group intercom
Intercom pairing
Cancelling operations
Play/Pause music
Turn on/off FM radio
Check battery
Speed dialing
Standby/Music/
FM Radio
Redial the last call
Voice command help
Check connected devices
Configuration menus
SRL2
Voice Command
"Intercom
[one, two, ... , nine]"
"End intercom"
"Last intercom"
"Group intercom"
"Pairing intercom"
"Cancel"
"Music" or "Stereo"
"FM radio"
"Check battery"
"Speed dial
[one, two, three]"
"Redial"
"What can I say?"
"Connected
devices"
"Configuration"
31