GLO NEO Stick Handbuch Seite 3

Quick Start Guide
4
EN
BG
CZ
EL
IT
KZ
PL
RO
RU
UA
For any error messages or advice on trouble shooting sections
please refer to local website.
Insert NEO™ Stick
into device.
Turn on by pressing
the button. Device
will vibrate once
after 3 seconds for
Standard mode, or
twice after 5 seconds
for Boost mode.
Wait for the next
vibration. NEO™
Stick is heated.
You can now start
your session.
Lift glo™ to your lips
and inhale gently,
when the device
vibrates again you
have 20 seconds left.
After use, discard
the NEO™ Stick.
Clean
Ensure the glo™ tobacco heater has been allowed to cool
for a minimum of 5 minutes before cleaning.
Open the cleaning door at the bottom of the glo™ tobacco heater.
Use a tissue to wipe away any collected moisture from the bottom
of the device and cleaning door.
For best performance, moisture at the cleaning door and bottom of
the glo™ tobacco heater needs to be removed after every 5 sessions.
After x5
sessions
After x5
sessions
To clean the inside of the heating chamber, open the slider door at the
top and the cleaning door at the bottom of the glo™ tobacco heater.
Clean the heating chamber using the brush provided.
For best results, clean from both ends as required.
For best performance, the glo™ tobacco heater cleaning chamber
needs to be cleaned after 20 sessions.
After x5
sessions
How to clean the
cleaning brush
Simply rinse brush under running water.
Please make sure that the cleaning
brush is dried when using again with
glo™ tobacco heater.
1 2
WARNING!
ATTEMPTING TO REMOVE DEBRIS BY FIRMLY
TAPPING OR SHAKING THE glo™ TOBACCO
HEATER MAY RESULT IN DAMAGE
1 2
1 2
5
EN
BG
CZ
EL
IT
KZ
PL
RO
RU
UA