Bestway 58628 Handbuch Seite 3

AQUASWEEPER
WARNING!
THIS IS NOT A TOY!
- Do not let children use or play with the cleaner. Assemble and disassemble this
product by adult only.
- Do not allow swimming in the pool while the cleaner is in use.
- TURN OFF THE PUMP before connecting cleaner to the pool.
- If there are stones, roots, or metal corrosion in contact with the bottom side of the
liner, clean them out before installing the cleaner. If necessary, have a qualified
professional do the cleaning.
- If the liner is brittle, damaged or wrinkled, have a qualified professional perform the
necessary repairs or liner replacement before installing the cleaner.
- Make sure the cleaner is not in the pool during any chemical sanitization.
- TURN OFF THE PUMP before servicing the cleaner or performing any maintenance.
NOTE: Drawings for illustration purpose only. May not reflect actual product. Not to
scale.
SAVE THESE INSTRUCTIONS
Automatic Pool Cleaner for Above Ground Pools
Cleans the bottom of your pool automatically. Works with all major brands of soft-wall
pools. This product includes 24.5 ft. (7.50 m) of hose to fit pool sizes up to 22 ft. (6.71 m).
This is a unique automatic above ground pool cleaner that is compatible with sand
filters as low as 800 gal./h (3,028 L/h) and up to 3,000 gal./h (11,356 L/h), and
compatible with filter pumps as low as 1,000 gal./h (3,785 L/h) and up to 2,500 gal./h
(9,463 L/h).
The Automatic Pool Cleaner has a built-in filter that prevents clogging of your hoses
and filter system. Before connecting the Automatic Pool Cleaner, inspect the unit to
make sure the bottom plate is properly locked in position and that the mesh bag is
clean.
IMPORTANT: Wait 4 hours to use the cleaner after chemical maintenance. The high level of chemicals will damage the diaphragm.
IMPORTANT: After every use, the diaphragm needs to be washed with clean water for 1 minute.
HOSE SECTION ASSEMBLY
Connect F3 - K - B - A in order, then connect the long hose sections (A+A+A...)
For 22 ft. (6.71 m) round & rectangular pools, connect all 10 long hoses
(A+B). For pools smaller than 22 ft. (6.71 m), reduce the number of long
hoses (A) simultaneously until total length of hose assembly is equivalent to
the length from skimmer/dedicated suction line to the farthest point in the pool
plus a length equal to hoses A. (Fig. 1)
HOW TO CONNECT YOUR AUTOMATIC POOL CLEANER TO POOL
Note: Turn filtration OFF before connecting the Automatic Pool Cleaner to your pool.
1.
The 2 connectors (F /F
1
market. Choose the right connector and see the following diagrams for proper connection to the water outlet of your pool.
F connection mode
3
Detach the strainer plug and insert the F
303021238513_58628_14x21cm 水力驱动清洁器说明书_英
OWNER'S MANUAL
) and Connection Hose A enables the Automatic Pool Cleaner to fit most brands of Above Ground Pools in the
3
into the strainer hole.
3
(1)
F
(2)
3
Parts Reference Overview
A. Long hose
B. Long hose
D. Pouring weight
F . Connector
1
F . Connector
3
K. Regulator valve
Fig. 1
F
(3)
F
3
3
3