JANE BABYSIDE Gebrauchs- Und Aufbauanweisung Seite 15

6
4
3
2
1 1
Adjusting the height of the mattress (6 heights)
-To adjust the height of the mattress, release the safety locks on each side.
-Keep the round button (1) pressed, keep button (2) pressed down or to the centre and simultaneously turn the
height adjuster 180º clockwise or anti-clockwise to raise or lower the height of the mattress to the next locking
position...
-Each half circumference of the dial is equivalent to a height position.
2
3
6
1
4
3
2
1
1
*Note: The mini cot can be tilted with a maximum difference of 2 positions between one side and the other.
The baby's head should always be in the highest part of the cot.
Removing the upholstery
a) Remove the mattress and unfasten the Velcro strips on the bottom of the upholstery attached to the base
frame.
b) Open the 2 front zips found on each side of the window, slide the buttons on each end of the front bar
outwards and remove the bar.
2 2
1
c) Unfasten the Velcro strips of the two side sleeves covering the vertical tubes.
d) Unfasten the zip found on the top frame of the mini cot and take the upholstery off completely.
e) With the cover separated from the structure, use your finger to open the small hole at the end of the metal bar.
f) Push the bar from the covered end and take it out through the hole until it is completely removed.
g) After washing, reinsert it fully through the hole and fasten it again with the Velcro.
ATTENTION: NEVER USE THE BABYSIDE MINI COT WITHOUT THE METAL BAR FITTED IN THE WINDOW.
1º
OPEN CLOSE
2º
15