Gima LD-202 Handbuch Seite 39

39
Table 2
Guidance and declaration of manufacturer-electromagnetic immunity
(For home healthcare environment)
The device is intended for use in the electromagnetic environment specified below.
The customer or the user of the device should assure that it is used in such an environment.
IMMUNITY test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Electrostatic
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions
and voltage
variations on power
supply input lines
IEC 61000-4-11
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
IEC 60601 Compliance
test leve level
± 8 kV contact ± 8 kV contact
±2 kV, ±4 kV, ±2 kV, ±4 kV,
±8 kV, ±8 kV,
±15 kV air ±15 kV air
± 2 kV , 100kHz, ± 2 kV ,
for AC power 100kHz, for AC
port power port
±0.5kV, ±1kV ±0.5kV, ±1kV
(differential (differential
mode) mode)
0% UT; 0% UT;
0,5 cycle 0,5 cycle
At 0°, 45°, 90°, At 0°, 45°, 90°,
135°, 180°, 135°, 180°,
225°, 270° 225°, 270°
and 315° and 315°
0% UT; 0% UT;
1 cycle 1 cycle
and 70% UT; and 70% UT;
25/30 cycles 25/30 cycles
Single phase: Single phase:
at 0° 0% UT; at 0° 0% UT;
250/300 cycle 250/300 cycle
30 A/m; 50Hz 30 A/m; 50Hz
or 60Hz or 60Hz
ENGLISH
Electromagnetic environment
-guidance
Floors should be wood, concrete
or ceramic tile. If floors are cov-
ered with synthetic material, the
relative humidity should be at least
30%.
Mains power quality should be
that of a typical commercial or
hospital environment.
Mains power quality should be
that of a typical commercial or
hospital environment.
Mains power quality should be
that of a typical commercial or
hospital environment.
Power frequency magnetic fields
should be at levels characteristic
of a typical location in a typical
commercial or hospital environ-
ment.