DeWalt DCM575 Bersetzt Von Den Originalanweisungen Seite 52

EnGLIsh
TROUBLESHOOTING
Problem Solution
Unit will not start. • Check battery installation.
• Check battery
charging requirements.
• Check that lock off is fully pushed
down prior to moving main trigger.
Unit shuts down • Charge battery.
in use.
• Unit is being forced. Restart and
apply less pressure.
Battery • Insert battery into charger until red
won't charge. charging light illuminates. Charge up
to 8 hours if battery is totally drained.
• Plug charger into a working outlet.
Refer to Important Charging Notes
for more details.
• Check current at receptacle by
plugging an appliance.
• Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
the lights.
• Move charger and appliance to
a surrounding air temperature of
above 4.5 °C or below 40.5 °C.
Bar / • Refer to Adjusting Chain
Chain overheated. Tension section.
• Refer to Chain Oiling section.
Chain is loose. • Refer to Adjusting Chain
Tension section.
Poor cut quality. • Refer to Adjusting Chain
Tension section. nOTE: Excessive
tension leads to excessive wear and
reduction in life of bar and chain.
Lubricate before each cut. Refer to
Replacing the Saw Chain section.
Unit runs but does • Chain could be installed backwards.
not cut. Refer to sections for installing and
removing chain.
Unit does not oil. • Refill oil reservoir.
• Clean guide bar, sprocket and
sprocket cover. Refer to Care And
Maintenance section.
50