Model Hc-300 Description, Specifications And Standard Equipment Description; Specifications; Standard Equipment; Icons - RIDGID HC-450 Bedienungsanleitung

Chuck
GFCI
Arbor
Pilot Drill
Figure 1 – HC-450 with Standard Equipment
Model HC-300 Description,
Specifications And Standard
Equipment
Description
The RIDGID ® Model HC-300 Hole Cutting Tool is de-
signed to cut holes up to 3" diameter into steel pipe. The
multiple hole size allows the use of Mechanical T's
Hookers ® , Vic-O-Lets™, Weld-O-Let™ and other fittings
for branching unpressurized pipelines.
The HC-300 features a 1 /
2
date all size of holes up to 3ʺ diameter and standard
hole saw arbors up to 7 / " Hex (
16
motor and gear reduction optimizes the performance
and saw life in the capacity range. A single feed handle
and ON/OFF switch allows for easy operation. The com-
pact two-piece design allows the HC-300 to be used in
tight quarters and difficult-to-reach locations.
NOTE! Mechanical T's, Hookers, and Vic-O-Lets are
registered trademarks of Victaulic Tool Company.
Feed
Handle
Chuck
GFCI
Chuck Key
Figure 2 – Model HC-300 with Standard Equipment
999-998-050.09_REV. C
ON/OFF Switch
Gib Screw
Feed
Handle
Swivel
Handle
Chain
Chuck Key
" capacity chuck to accommo-
1 / " chuck size). An integral
2
ON/OFF
Switch
Warning
Label
Crank Screw
Assembly
Chain
HC-450/HC-300 Hole Cutting Tools

Specifications

Cutting Capacity ............Up to 3" (76mm)
Pipe Mounting
Capacity ........................1
Drill Chuck Capacity ......
Drill Chuck Speed..........360 RPM
Motor Horsepower.........1.2 HP
Current Draw Rating......11 Amps @ 120V
Sound Pressure (L
Sound Power (L
* Sound measurements are measured in accordance with a standardized test per
Standard EN 62841-1.
- Sound emissions may vary due to your location and specific use of these tools.
- Daily exposure levels for sound need to be evaluated for each application
and appropriate safety measures taken when needed. Evaluation of expo-
sure levels should consider the time a tool is switched off and not in use. This
may significantly reduce the exposure level over the total working period.
Dimensions
Height ............................12.8" (32.5 cm)
Length ...........................11.9" (30.2 cm)
® ,
Width .............................13.2" (33.4 cm)
Total Weight ..................31 lbs. (14 kg)
Base ...........................10 lbs. (4.5 kg)
Motor Assembly..........21 lbs. (9.5 kg)

Standard Equipment

• Hole Cutting Tool (Base and Motor Assembly)
• Chuck Key
Figure 3 – Machine Serial Number
For both the HC-450 and HC-300 Hole Cutter Tool, the
serial number is located on the underside of the motor.
The last 4 digits indicates the month and year of the
manufacture (MMYY).

Icons

Power ON
Power OFF
1 / " - 8" (30mm-200mm)
4
1 / " - 1 / " (2mm-13mm)
16 2
5.5 Amps @ 220-240V
12 Amps @ 100V
)* ......97.4 dB(A), K=3
PA
)*...........101.43 dB(A), K=3
WA
XXXXXXXXMMYY
5