Current Source Mode (continued)
i=2
i=2
i=20
i=20
Sure
Current Sink Mode
Display
Switch on Power, Calibrate link In CAL Position
u=0
Connect Power Supply and Multimeter to measure output current (mA).
i=2
i=2
i=20
i=20
Sure
External Voltage Inputs
Display
Note: you must calibrate the Voltage Source Mode before completing this procedure.
Switch on Power, Calibrate link In CAL Position
u=0
Connect voltage source and Set to 0 V.
U=0
QS61001066_Portacal1000_Buch.ind27 27
Õ Ù â á
Ó
On
Off
Off
Õ Ù â á
Ó
Ó
I+
I-
V
Keys
Off
Off
On
Ò Ò
Õ Ù â á
Ó
Off
On
Off
Õ Ù â á
Ó
Ó
I+
I-
V
Keys
Off
Off
On
Ô Õ Ù Ù Ó
Off
Off
On
Ó
Adjust Output Current to 2 mA
Accept output
Adjust Output Current to 20 mA
Accept output
To Save Values (or any other key to restart).
Action
Press twice to select Current Sink mode
Adjust Output Current to 2 mA
Accept output
Adjust Output Current to 20 mA
Accept output
To Save Values (or any other key to restart).
Action
Press sequence to select External Voltage
mode. INC and DEC Leds will both light.
Calibrate 0 V point
7
25.01.2008 14:52:54 Uhr